Out of stock


Add 2 rear L & R buttons to your Gameboy Zero Gaboze Pocaio project with this simple kit.

This kit uses soft tactile buttons to add L1 and R1 buttons to your build, the bracket uses the Gameboy Pocket case and the PCB tension to hold them snug in place, so no need for any screws or glue!

To install, simply add the caps to the buttons, use the bracket to mark your drill holes, drill to about 9.5mm with the step tool (be careful not to go too far!), pop the buttons in, place the assembled bracket in so it sits snug at the bottom. Then wire the buttons to the inputs on the board and you’re done

Super easy to add your L1 and R1 buttons to any Gameboy Zero Gaboze Pocaio build !

You can view the install guide here

Buttons available are:

  • Black
  • Red
  • Clear
  • White
  • Grey
  • Clear Orange
  • Clear Green
  • Blue
  • Clear Blue
  • Aqua
  • Green

Each pack contains:

  • 2x Soft Tactile Buttons
  • 2x Button adapters
  • 1x Bracket

The bracket is printed in a strong PLA material, available in the following  colours.

  • Clear
  • Neon Yellow
  • Pink (touch sensitive and goes white at 30 degrees)
  • Black
  • Silver
  • Light Blue (touch sensitive and goes white at 30 degrees)
  • White
You must provide a valid email address to join the waitlist for this product

Related Products